5. SYSTEM SETTINGS
45
To install an option, follow the procedure below.
1. Press SYS, F•5 next menu, and then F•4 LICENSE SETUP.
The license display appears.
Figure 5-10 License display
2. Enter the 10-digit license key number for the option that you want to install.
The key operations that you can perform on the license display are as follows:
F•1 CLEAR:
Deletes the license key that you are currently entering
F•2 CHAR SET:
Enters the selected number
F•D 1 CHAR SELECT: Turn to select a number, and press to enter the number.
3. Press
F•3
REGISTER.
“ACCEPTED” appears after a license key has been entered correctly, and its
corresponding option becomes usable. The name of the option that has been added
appears in the LICENSE LIST.
“FAILED” appears if the license key is not correct. Enter an appropriate number.
To remove an installed option, enter the license key, and then press F•4 REMOVE.
5.9.2
Viewing the MAC Address and Installed Options
Use the license display to view the MAC address of the LV 5381 and the options that are
installed in the LV 5381.
The options (sold separately) that the LV 5381 supports are shown below.
Table 5-2 Supported options
Option Number
Name
Notes
LV 5381 OP70
REMOTE & TALLY
Factory option
LV 5381 SER01
DUAL LINK
Requires a license key
LV 5381 SER02
AUDIO LISSAJOUS DISPLAY
Requires a license key
LV 5381 SER03
STATUS DISPLAY
Requires a license key
LV 5381 SER04
3D ASSIST
Requires a license key
