Leader LT4610-SER01, Instruction Manual

Page: 188 / 272

19. SYSTEM MENU
167
19.7 Setting the Time Code (SER01/SER03)
Under SYSTEM→TIMECODE, you can set the time code.
０．ＳＹＳＴＥＭ

ＴＩＭＥＣＯＤＥ
↵
19.7.1 Selecting the Time Code
To select the time code type, follow the procedure below.
Time codes are inserted into black, SDI, and AES/EBU signals and are also output from LTC
IN/OUT on the rear panel.
２．ＴＩＭＥＣＯＤＥ ＳＯＵＲＣＥ
◄►＊ ＩＮＴＥＲＮＡＬ
Procedure
SYSTEM → TIMECODE → TIMECODE SOURCE
Parameters
GPS:
The date and time in the GPS signal received through GPS IN on the rear
panel are used.
INTERNAL: The date and time selected in section 19.6.1, “Setting the Date and Time,”
are used.
LTC0: The date and time in the LTC signal received through LTC IN/OUT on the
rear panel are used.
VITC: The date and time in the VITC signal received through GENLOCK IN on the
rear panel are used.
* If the SER03 is installed, the selectable settings are limited depending on the genlock mode
setting. For details on the genlock mode settings, see section 10.1, “Selecting the Genlock Mode.”
The following table shows the relationship between the genlock mode setting and the
internal time type for when the SER03 is installed.
Genlock mode TIMECODE SOURCE
INTERNAL
10MHzCW (SER01) INTERNAL
LTC0
GL FMT-AUTO
GL FMT-MANUAL INTERNAL
LTC0
VITC
GPS (SER01) GPS
PTP (SER03) PTP