15. View Finder Display
15-1
15. View Finder Display
The LV 5330 can display the picture of a composite video signal received from a camera. Apply
a composite video signal to INPUT VIEW FINDER on the back panel, and press VIEW FINDER.
The composite signal cannot be shown in other displays (such as the video signal waveform
and vector displays), and its picture cannot be incorporated into the multi-screen display.
The input format (NTSC or PAL) is detected automatically and displayed in the upper left of the
screen.
In the view finder display, the menu and the information displays at the top of the screen
disappear approximately five seconds after the last operation is performed. To redisplay the
menu and information, perform some kind of operation.
Figure 15-1 View finder display
15.1
Adjusting the Brightness
You can adjust the brightness of the picture by turning BRIGHT.
Pressing BRIGHT returns the brightness to its default setting (0 %).
Settings
Selectable range: –50 % to 50 % (The default value is 0 %.)
15.2
Adjusting the Contrast
You can adjust the contrast of the picture by turning CONT.
Pressing CONT returns the contrast to its default setting (100 %).
Settings
Selectable range: 50 % to 150 % (The default value is 100 %.)
