Fig. 2: Installation Clip TS Battery Charger
6 Assembly
Fig. 3: Mounting the
TS battery charger
To mount the battery charger, proceed as follows:
ü
Choose a cool, dry and well-ventilated assembly site.
1. Remove the installation clip (5).
CAUTION!
To avoid damaging the lock (4), release
the installation clip from the left side.
2. Mark the holes for the installation clip (5) at the
mounting location.
3. Drill the 3 holes (Ø 3.5 mm).
4. Attach the installation clip (5) with the screws included.
5. Cover the screw heads with the screw covers.
6. Insert the battery charger into the installation clip (5).
ð
The battery charger is mounted.
7 Installation
Fig. 4: TS charger in-
put lead
To install the battery charger, proceed as follows:
1. Disconnect the vehicle battery from the vehicle power
circuit.
CAUTION!
Disconnect the negative cable first.
2. Connect the red wire of the input lead (1) to the posit-
ive terminal of the vehicle battery.
3. Secure the positive cable as close as possible to the
vehicle battery with a suitable fuse.
NOTE!
TS 24/12-06: 10 A.
8
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
7 Installation
LEAB Automotive GmbH
