5. Screw the MagCode
PowerPort
on the back with a nut
(M28).
6. Connect the cables with each other by soldering,
crimping or with connection terminals.
7. Put the fuse back in place.
ð
The MagCode
PowerPort
is installed.
13.3 MagCodePowerClip assembly instructions
To install the device, proceed as follows:
1. Cut off the old connector.
NOTE!
Note the polarity of the wires.
2. Screw on the MagCode
PowerClip
.
3. Select the appropriate strain relief for the cable thickness.
4. If necessary, shorten the cable grommet by passing the cables through the
grommet and the strain relief and attaching the wire end ferrules.
5. Screw the cables into the terminals.
NOTE!
Note the polarity of the wires.
6. Screw the housing together.
ð
The device is assembled.
18
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
13 Appendix
LEAB Automotive GmbH
