To prolong the life of the product, the following measures should also be
taken:
– After outdoor use, clean the port briefly with a cloth.
– Remove possible deposits of metal chips on the contact side of the port and
clip with an adhesive strip from time to time.
– Spray contact spray on port and clip contacts every 1 to 2 months.
TIP
Device defect due to faulty release under load
The MagCode PowerSystemPro 12/24 V has a mechanical bayonet
lock. It can be disconnected under load without unlocking, which
can damage the system or cause the system to fail completely.
1. Always unlock the system manually.
13.2 MagCodePowerPort installation instructions
Fig. 3:
MagCode
PowerSystems clip
and port
NOTE!
An existing car socket can easily be replaced by a
MagCode PowerPort, as both have the same diameter. If
installing elsewhere, we recommend visiting a specialist
workshop.
To install the MagCode
PowerPort
in place of an existing
car socket, proceed as follows:
DANGER!
Short circuit hazard - Remove the fuse be-
fore starting work.
1. Pull out the existing car socket.
NOTE!
Note the polarity of the wires.
2. Cut the cable.
OR…
3. Drill a new installation opening (Ø 28 mm).
ð
The installation opening is prepared.
4. Slide the MagCode
PowerPort
, with or without spacer
ring, into the installation opening.
17
LEAB Automotive GmbH
Thorshammer 6
24866 Busdorf
LEAB Automotive GmbH
13 Appendix
