Le Las 227A1AT, User Manual

Page: 57 / 64

NFC227A*TEL2
57 /64
\\SERVEUR MAX\\ Notices NFC \ NFC227 TL2 \ NFC227A-TEL2.DOC
•
Programming code Time Silence
*13xx* Length of Silence prior to auto-cleardown
Factory setting xx = 00 The telephone does not clear down on silence
Example xx = 30 Auto-cleardown after 30 seconds
Up to xx = 99 Auto-cleardown after 99 seconds
Note: steady frequency tones, whether cadenced or not, are taken as silence.
•
Programming code Ring Modulation
*15xx* Type of ringing modulation
Factory setting xx = 00 Pure frequency
xx = 01 Mixed frequencies
•
Programming code Push Button
*17xx* Continuous time-button M pressed before line taken
Factory setting xx = 00 Line taken immediately
Up to xx = 98 Action deferred 9.8 seconds
If xx = 99 button disabled
DIRECT MEMORY ACCESS BY « R » BUTTON AND DIALLING CHAIN IS ONLY
AVAILABLE IN HAND-FREE MODE
•
Programming code T1 : CHAINING MODE
*20xx* Time in seconds before passing from M1 to M2 to chain
autodialling
Factory setting xx = 00 No number chaining
Up to xx = 99 99 seconds on M1 before passing to M2
Note: during number chaining, there are two options - if T1 is an even number the loudspeaker reproduces
the telephony on the line (dialling-tone, busy, dialling etc…). If T1 is an odd number the loudspeaker
generates a cadenced calming tone and the indicator flashes to the same rhythm.
•
Programming code T2 : CHAINING MODE
*21xx* Time in seconds before passing from M2 to M3, M3 to
M4, up to M8 to chain autodial numbers
Factory setting xx = 00 No number chaining
Up to xx = 99 99 seconds on MX before passing to the next
Note: during the chaining of numbers in T2, it is the parity of T1 which determines the telephony on the
loudspeaker.
A
TTENTION