Cetra 10/28 & 20/40 3200K and 5600K White LED User’s Manual – 2.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
4
letter E or with the symbol or coloured in green or in green-yellow
•
The blue wire must be connected to the connection point marked with the letter N or with the
symbol or coloured in black
•
The brown wire must be connected to the connection point marked with the letter L or with the
symbol or coloured in red
•
Before you finally position this product for use, temporarily connect it to a properly fused power supply
to check the lamp works correctly.
6.
VOLTAGE
Before operating this unit please refer to the product label mounted at the back of the luminaire to check
you are operating with the correct voltage.
The SAMBA A100 CM
can be operated between 90V and 260V
and the electronic PSU inside the fixture
will automatically switch to the available voltage.
7.
FREQUENCY
Frequency on this product is automatically selected by the electronic PSU (50/60Hz)
8.
CONTROL FUNCTIONS AND OPERATION
OPERATION: LCD display for DMX address, system setup and status details.
POWER: power LED status indicator , red color. ON= power
DMX: DMX LED status indicator, green color. LED OFF = DMX OFF and manual control activated , LED ON =
DMX MODE activated with no DMX signal, FLASHING LED = receiving DMX
MENU: rotary switch selector to select and modify the operational modes. Turn left or right to navigate
through the menu and press to select or to confirm
DMX IN: input DMX signal (pin1=0 , pin2= DATA- , pin3=DATA+ ).
DMX OUT : Loop through DMX signal output
POWER IN: Mains power input
POWER OUT: Mains power output
FUSE: 5x20 6.3A HPC FAST
9.
MENU
There are thirteen different operation menus for the setting of the CETRA LED control functions. The
rotary selector is used to adjust the settings and to navigate through the menu structure. Turn left or right
to select the menu and push to access or to confirm the selected data or functions.
9.1 DMX OR MANUAL (Mode):
Select the LED control mode between DMX (factory setting) and manual. To change the control mode press
once the rotary selector until an arrow (
) appears on the menu. Turn the selector to the right or the left to
select the desired mode of operation and press to confirm your selection.
