LC Packings Probot 161403, User Manual

Page: 41 / 118

Installation and Getting Started
User’s Manual Probot
D960R3
2-21
2.7.4 Checking and Modifying Application Parameters
The next step is to check and/or modify the application parameters. After the
application parameters have been checked/modified, the alignment of the sample
carriers should be checked (Section 2.7.3).
2.7.4 A Checking and Modifying Groups
All predefined applications have a tray setup with the maximum number of
sample carriers on the tray, one group per sample carrier and a meander spotting
pattern.
FIGURE 2-17 6 Sample Carriers, 1 Group on each Sample Carrier
Check if this groups setup fulfills the requirements of the application you need to
perform. If not, the group setup can be modified as follow:
a) Select a group in the group list (e.g. click on ‘LC_Collect_1 in the table).
b) To remove all spots from this group, use the Clear Group button.
c) To assign non-grouped spots to a certain group, mark the spots with the
mouse cursor.
d) To change the spotting pattern, select the appropriate spotting pattern from
the drop down menu.
e) Add a new group with the Create a new Group button.
1