ruby standard configuration User Manual
Version: 6.4.0/2
27/179
6. Installation
3
.
Insert the new card into the slot, and gently slide it into the frame:
Make sure that the card glides smoothly into the side guide-rails and sits flush with the rear panel casing.
If you are hot plugging a card, then after a few seconds, the card will boot. You can check the status of the
new card from the
(go to the
System
->
States
page).
4.
Now fasten the two screws to fix the card in place.
CAUTION
:
ALWAYS
secure the IO card using the screws provided. This protects the operator from
contact with live parts; protects the card from being pulled out unintentionally; and reduces the emission of
electro-magnetic radiation.
5.
When you have fitted all the IO cards for your system, check that all cards are screwed into the frame
and that any empty slots are closed with metal cover plates.
The installation is now complete, and you can wire your audio devices to the IO card connectors.
6.2.7
SFP Modules
To use a CONTROL, RAVENNA/AES67 or MADI port, you must fit an SFP module. All SFPs must be Lawo-
certified (as listed below). SFPs are not included and must be ordered separately. You will need one SFP for
each port.
If fitting SFPs to both MADI and network interface ports, take care not to mix up the SFP types.
Ø
Network Interface SFP Modules
SFP Module Description
Part Number
1000 Base-SX: 850nm, -7dBm, multi-mode fiber, 550m
981/60-10
1000 Base-LX: 1310nm, -3dBm, single-mode fiber, 10km
981/60-20
1000 Base-ZX: 1550nm, 0dBm, single-mode fiber, 80km
981/60-30
1000 Base-T: RJ45, copper, 100m
981/60-60
Ø
MADI SFP Modules
SFP Module Description
Part Number
MADI, 1310nm, multi-mode fiber, 2km
981/60-80
MADI, 1310nm, single-mode fiber, 20km
981/60-81
MADI, HD-BNC (75 ohm), copper, 100m
981/60-82
