ruby standard configuration User Manual
Version: 6.4.0/2
125/179
9. The Web UI
Supervisor Mode
In
Supervisor
mode, the following sections become visible.
Ø
Control Functions
By default, an on-screen message appears whenever the system restarts. You can turn the messages off by
checking the "Suppress restart messages" box.
The next four options define which network port(s) can be used for Netcom, DMS, MNOPL and EmBER+
communication. In each case, you can choose either
any
(to allow access via any network port) or
dwc0
(to
restrict access to CONTROL A only). Note that if you choose
dwc0
, then the restriction also applies to the local
host and so access is not permitted via 127.0.0.1. The default setting for all protocols is
any
.
The Ember+ Whitelist (configured in ON-AIR Designer) can be used to restrict the access to the Ember+
providers so that only devices with a defined IP can talk to Power Core (via Ember+). For convenience, you
can turn on the "Disable EmBER+ Whitelist" option to temporarily deactivate the whitelist. This will allow access
from consumers with any IP address.
The two red buttons at the bottom of the area can be used to restart the system as follows:
·
Reboot (Coldstart).
Reboots the unit and loads the base configuration parameters (as defined by the
ON-AIR Designer software). This will clear any temporary changes made from the Web UI.
·
Reboot (Warmstart).
Reboots the unit keeping temporary changes intact.
Ø
Front Display
The “Editing disabled” box is checked by default. If unchecked, the unit’s IP Address and other settings can be
changed using the display and selection knob on the Power Core’s front panel. Lawo recommends keeping
front panel editing disabled.
When using the front panel controls, inactivity causes the display to return to its normal status. You may set a
timeout period for this action by entering a value, in seconds, in the “Edit Mode Fallback Time” field.
The "Identify" box can be used to send a message to the
easily identified. The message shows the dwc0 IP address.
Ø
Web UI Preferences
Use these options to adjust what is shown in the browser's "title" for the session.
Ø
Download Files
You can use these options to download files from Power Core onto your computer. To proceed, first select the
tick boxes and then click on the green
Download
button.
