POWER CORE User Manual
Version: V6.0.0/5
189/459
13. Control Surface Configuration
13.4.1 Default Fader Assignments
The following parameters enable or disable layering, and configure the default sources for each fader strip:
Module
The reference name for the Module.
Disable Layer 2
Tick this box to disable Layer 2 switching. This will disable the
ACCESS 2
keys on the
Fader Module. Once Layer 2 is disabled, the
ACCESS 2
key can be reassigned to
another function by defining MF Key 5 for the source, see
Default Sources
Assigns a default source or sum bus to the fader strip. This source is loaded whenever
the configuration is transferred, or the system is reset using a
. You can
permanently assign this source to the fader strip by ticking
Only Default
.
·
Use boxes
1.1
,
1.2
,
1.3
,
1.4
to assign Layer 1, strips 1 to 4
·
Use boxes
2.1
,
2.2
,
2.
3,
2.4
to assign Layer 2, strips 1 to 4
Only Default
Tick this box if you wish the
Default Source
to be permanently assigned to the fader
strip.
13.4.2 Fader Assign Options
There are two ways in which sources can be assigned to fader strips:
·
Fixed assignments - where a source or summing bus is permanently assigned to a fader strip.
·
Flexible assignments - where operators can scroll through a pre-defined list of sources and summing
busses to make assignments from the fader strip.
