LAWO mc256 MKII, Technical Manual

Page: 362 / 372

mc²56 MKII Technical Manual V5.10.2/1 362
Chapter 7: Appendices
SDI Parameters
SDI Card
Select an SDI card from the System tree, and click on SDI to adjust the following card parameters:
·
SRC – check this option to enable sample rate conversion. Note that SRC is applied to all 8 channels on
the card. Normally, SRC should be enabled. If SRC is off (unchecked), then the system must be clocked
to the same reference as the sending device.
·
Delay – select whether delay is enabled for the Embedded (SDI output) or De-embedded (SDI input)
signals; delay cannot be applied to both.
·
Generator signal , mode and format – defines the output generator signal for the SDI stream.
·
Embedder mode – select from:
o
On – audio channels will be replaced within the existing SDI data structure according to your SDI
output group selections.
o
Off – no audio replacement; the SDI stream remains unaltered.
o
Clean – deletes the incoming audio stream and generates a new data structure according to your
embedder settings. Note that if you select this mode any existing audio data will be lost.