LAWO mc256 MKII, Technical Manual

Page: 210 / 372

mc²56 MKII Technical Manual V5.10.2/1 210
Chapter 3: AdminHD
Core Configuration: Parameters
Signal In -> Signal
Signal In parameters depend on the type of signal (Mic, Line, AES, SDI, etc.). Below are two examples. See
also SDI Parameters .
Mic Signal In Parameters AES Signal In Parameters (with SRC)
HLSD High Level Signal Definition - this is the Lawo system address for the signal. It
MUST be unique, and normally you should not modify this address from its default
setting.
Signal name This is the system name of the signal. It can only be defined by AdminHD, and should
be used to provide a "fixed" signal name relevant to the installation.
Signal label This is the user label which the system resets to after a cold start. Users can change
labels later, from the console GUI's Signal List display.
Group This is the group name for the signal. It can be used when interfacing to an external
controller . Please refer to your external system’s documentation for details on how to
implement the group name.
SRC For AES cards with SRC only.
Tick this box to enable the sample rate converter. Users can change this parameter
later, from the console GUI's
Signal Settings display.
For details on an individual card's parameters, please refer to the relevant data sheet available in the
"
mc2_Nova73_documentation " guide.
To make a digital path suitable for Dolby E operation, you should turn off the I/O DSP for both the input and
output, and disable any sample rate conversion.