LAWO mc256 MKII, Technical Manual

Page: 179 / 372

mc²56 MKII Technical Manual V5.10.2/1 179
Chapter 3: AdminHD
Signal List Configuration
Selection Tips and Tricks
When adding signals, you can use the following tips and tricks to edit the contents of the Selected signals
column.
(The same tips can be used when deleting signals, but you would make selections in the Directories & signals
column.)
·
To select all the signals from a card, click on the card within the Hardware Tree - all signals within the
card are added to the Selected signals list.
·
To select a range of consecutive signals or cards, select the first signal or card; press and hold SHIFT
(on your computer keyboard), and then select the last signal or card - all signals within the range are
added to the
Selected signals list:
·
To select non-consecutive signals or cards, press and hold CTRL (on your computer keyboard) and then
click on the signals or cards. As long as you continue to hold the CTRL button, your selections
accumulate within the Selected signals list:
·
To remove a signal, from the Selected signals column, select the signal and click on the button.
Note that this function only edits what is in the Selected signals column. If you wish to remove a signal
from a subdirectory, then see deleting signals .