crystal User Manual
Version: 6.6.0/2
193/459
10. Audio Mix Engine
10.5.4
PFL-related Source Settings
For each source defined in the 'Tree Definition', open the
PFL
tab to edit the source-specific PFL parameters.
These functions are triggered by the rising edge of the input control signal.
PFL On
Turns On PFL for the source.
PFL Off
Turns Off PFL for the source.
PFL Toggle
Changes the state of the source PFL.
The following control outputs appear in the ‘Tree Selection’ under “Logic -> GroupName -> SourceName”.
PFL active
Active when the source is routed onto the PFL bus (
PFL On
).
PFL prepare
Active when the source is in ‘PFL Prepare’. This state occurs when you turn on PFL for an open
fader in either PFL R or PFL SUM R mode. Your monitoring does not change but the source is put
into ‘PFL prepare’. When you close the fader, PFL becomes active.
PFL off
Active when both
PFL active
and
PFL prepare
are off.
PFL in use
Active if either
PFL active
or
PFL prepare
are active.
PFL assigned
Indicates which PFL bus (1 to 5) is assigned as “PFL 1”.
PFL 1 may be swapped with another PFL bus (from 1 to 5) from “
Surface -> Fader Module -> PFL1
”.
