crystal User Manual
Version: 6.6.0/2
192/459
10. Audio Mix Engine
10.5.3
PFL Global Settings
"System -> Definition -> Parameter = PFL Mode"
This branch of the 'Tree Definition' configures the PFL modes for each listen bus. To use PFL 2 to 5, you must
first create a user-defined bus for each additional listen bus required. This is done using Sum Buses in the
manner. Note that PFL 3, 4 and 5 are not supported by
crystal
.
Start by selecting "
System
->
Definition
" in 'Tree Definition' and the
Audio
tab. Scroll down to access the
"
Parameter
=
PFL Mode
" options:
Parameter
PFL Mode – reference name for the element.
PFL Mode x
Assigns a control signal to activate the corresponding PFL mode.
PFL Off
Assigns a control signal to reset any active PFL buttons to off.
PFL Swap to
Used in conjunction with the “
Fader Module -> PFL1 Swap parameter
” options.
PFL Sum
Assigns a sum bus to PFL 2 (and PFL 3, 4 & 5 on
sapphire
,
sapphire compact
and
Power
Core
).
No PFL when
Hotfader closed
When checked, PFL ignores the hot fader position. So, if you are working in
responds to the actual channel level and not the physical fader position.
