A__madi4 User Guide
Version: 10.0.0/4
25/68
11. Device Configuration
11.2
Network Service Address
This area displays the service network IP Address and Subnet Mask.
1.
Click on
EDIT
to change the service network IP settings - the device will reboot and you will lose your
browser connection.
2.
the Landing and then the Device configuration page to confirm the changes.
The service network IP Address can be reset to its default (
192.168.110.253
) using the
panel.
11.3
Interface Mode
This area displays the 'current' conversion mode for the connected BRIDGE. To change the mode:
1.
Use the radio buttons in the 'desired' column to choose a new mode.
2.
Then click on
ACTIVATE
- the device must reboot to activate the new mode.
3.
After the reboot, refresh the browser connection to check that the selected mode is now 'current'.
11.4
RAVENNA
1.
Click on
Open RAVENNA Butler
to open the
This is used to configure the streaming ports when converting to and from RAVENNA Net.
It is not required when converting to/from RAVENNA Link.
11.5
Software
The current version is shown in the 'Software' area. Please check this against the latest release, available from
the
Downloads
area at
Login
).
To perform an upgrade or downgrade:
1.
Download the software update file onto your computer.
Check that the downloaded file ends with
.tar.gz
Some browsers, such as Safari, tend to unzip the file automatically after download which makes the file invalid. If
this is the case, choose "Download as..." in your browser to bypass the automatic unzip function.
2.
Read the release notes supplied with the update file.
If settings will be lost as a result of an update, it is strongly recommended that you export your configuration
and/or take screenshots so that the current settings can be re-instated once the upgrade/downgrade is complete.
Details of which settings will be affected are included in the release notes.
3.
Click on
SELECT FILE
and choose the update file.
4.
Click on
UPDATE
to start the software update - this will take a few minutes and, when the update is
complete, the unit will reboot.
5.
Refresh the browser connection to check the new release version and that the Device is Ready (at the
bottom of the page).