A__mic8 / A__digital8 User Guide
Version: 10.0.0/4
53/66
12. Adjusting Local Parameters
12. Adjusting Local Parameters
The
Device Parameters
and
GPIO
pages allow you to remotely control the audio and GPIO parameters from
your service computer. Note that the latest values are stored locally on the device, and are re-instated following a
power cycle or reboot.
12.1
Using the Control Pages
1.
Open the
, select either
Device Parameters
or
GPIOs
, and then click on the graphical
preview.
Note that you must enter service mode to access the
GPIOs
!
The control page opens in a new browser tab - in our example, the
Device Parameters
for an
A__mic8
:
At the top of the page you will see the device's Network Name (e.g.
A1
), and information including the web UI
version, serial number of the device and its firmware versions (top right). In the main area are the audio parameters
and metering.
2.
Touch and drag the sliders to adjust variable parameters.
3.
Touch the on-screen buttons to enable or disable switched functions.
