LawnMaster Eco Series, Manual, Page: 17 / 22

16
5.
Starting the Edger
Set the Engine On\Off switch to On (note some
models have a second On\Off switch mounted on
the engine. Both need to be On for the edger to
operate).
Move the throttle to Fast position.
If the engine is cold move choke control to CHOKE
position.
Pull starter cord gentle until resistance is felt then
pull the starter cord using a rapid smooth
movement to start the engine. Gently allow the
cord to recoil back into the engine.
Repeat the starting procedure above if necessary.
Once started move the choke control to RUN.
Caution
Only start the Edger with the Cutter
operating lever disengaged. Do not run the
engine in an enclosed area. Check Cutter
clearance to ensure it will not contact
anything once started