3
System Start Up
1.
Position the Camera Control Power Switch to ON (Figure 5 Item 3), on the Control Unit.
Position the Winch Power Switch to ON (Figure 2 Item 6), on the Winch Motor
Controller.
2.
Turn on the LCD Monitor. While watching the Monitor to verify operation Switch
between side and down view and adjust light intensity, with the VIEW-LIGHT Switch
(Figure 5 Item 5). The LED lighting should light up with the view selected. The light
intensity of the view selected can be changed by pressing LIGHT; this will cycle through
5 light intensity levels. Check the rotation by using the Cam Control FORWARD-REVERSE
Switch
(Figure 5 Item 4); both the Down View and Side Views will rotate
.
3.
Rewind any excess cable by using the Winch Motor Controller functions (Figure 2) to
position the Camera in the well, near the top. Press the Camera Control CLEAR Switch
(Figure 5 Item 6) to reset depth counter to zero (000.00f).
4.
Ensure the wireless keyboard is plugged into the Keyboard USB Input (Figure 5 Item 7)
and the supplied USB Flash Drive is installed into the Recording USB Input (Figure 5 Item
8). Press
R
on the wireless keyboard to begin recording. Press
S
at any time to capture a
NOTE: The Reel Control on the Control Unit does not operate the Winch.
The Winch Motor Controller and switches on the winch operate the Winch.
1
0
2
3
0
4
0
Figure 4
