7
Maintenance Instructions
•
Ensure the cable head is properly secured during transport and storage.
•
Regularly inspect the cable head o-ring condition and o-ring seal area for cleanliness.
This area should be free of debris and lubricated as needed.
•
The cable head will experience normal wear during use and will need to be replaced at
various intervals depending on care and usage. A Cable Head Repair Kit, Part# 126883,
is available to replace the cable head in the field as needed. It can be purchased at
•
Wash the Camera with fresh water and wipe clean after use. Ensure the camera is free
of unwanted oil and contaminates. If necessary, use mild dish soap to clean the camera.
•
Prior to and after conducting each survey, inspect the glass ports on the side-view and
down-view for any cracks or debris in crevices. If necessary, use household glass cleaner
to clean the viewing ports.
•
Inspect the cable head connection point at the top of the camera before connecting the
cable head to the camera. This area should be clean, free of debris, and the pins should
be in the upright position. If the pins are bent or deformed, do not attempt to connect
the cable head.
•
When not in use store the system in an indoor, temperature-controlled environment in
the carry case and foam pads provided.
•
Guide the cable evenly across the drum and wipe clean when spooling to prevent
contamination, build-up, and damage.
•
Keep the Control Unit clean and free of debris. Wipe clean after each use.
•
Before use check the lead screw for debris and dirt. Wipe clean as needed.
