LAURA ASHLEY
IL4540
Issue 1 04/22
BURDALE TRIPOD FLOOR LAMP
ASSEMBLY INSTRUCTIONS
These instructions are provided for your safety.
Please read carefully before commencing work and retain for future reference.
SAFETY INFORMATION
*
The supply cable runs through the inside of this product. Take care not to place undue stress on the cable whilst unpacking
to prevent the possibility of a poor connection.
*
If you are in any doubt consult a person competent to give advice on the assembly of electrical equipment.
*
Always be sure to use the correct type and wattage of bulbs as indicated on the fitting. Do not exceed wattage stated.
*
If the external flexible cable of the lamp is damaged it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualified person in order to avoid a hazard.
*
To prevent electrocution switch off at the mains supply before assembling or maintaining this fitting. Ensure the plug is not
connected to any power supply and read instructions before assembly.
*
When changing the bulb, always unplug from the mains and allow the old bulb to cool down before handling. Dispose of
used bulbs carefully.
*
If moving the floor lamp always carry it from the base. Do not lift the floor lamp by the stem only as damage may
occur
*
Place this product out of direct sunlight.
ASSEMBLY INSTRUCTIONS
1.
Unpack the product and remove all packaging. Be careful not to scratch the surface of the
product whilst removing the plastic wrapping.
2.
Lay the product out on the floor. If the floor is not carpeted please cover it with a soft
cloth to avoid damage to the flooring and surface of the product. Assembly should take
place with the product lying flat.
It may be necessary to remove protective packaging
(plastic / cardboard) located at cable.
3.
Slot the lower leg sections, one at a time into the upper lamp holder section ensuring the
screw fixing holes are visible through the metal bracket
4.
Insert 2 x screws through the metal bracket on opposite sides of the leg (4 per leg) and
fully tighten using the screwdriver tool provided
Repeat this step for all three legs.
5.
Bring one of the support braces up to the centre and place the securing screw though the
hole on the underside of the brace. Holding the screw from underneath with one finger,
align the second and third braces with the first, placing each hole in the brace over the
screw in turn
(note the leg positions may need to be adjusted in or out slightly to aid
alignment)
6.
Fit the securing nut to the top of the screw to secure the three brace sections together
7.
Stand the floor lamp upright and ensure all the assembled parts are fully tightened.
8.
Fit bulb: type and wattage as indicated on fitting.
The wattage indicated must not be
exceeded
9.
Floor lamp is now ready for use
.
GENERAL INFORMATION
This fitting is designed for internal use only.
Do not use polish or abrasive cleaner - just a soft dry cloth.
