29
Program Location 10 (PL10)
Right Coin Denomination
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “rCdE,” right coin
denomination for 3-seconds and the
right coin acceptor denomination
programmed (I.E. 25¢). If no
change, press “Perm Press” key,
otherwise press “HI” or “LO”
key and then “Perm Press” key.
Summary: The right coin denomination is programmable from 1 to 9999.
IMPORTANT: When the dryer is equipped with a dual coin acceptor, the value set here is the higher value denomination,
which is not necessarily the right coin portion of the acceptor.
NOTE: For single coin models this parameter need not to be set.
PL10
rCdE
Perm Press
25
HI Temp
Perm Press
LO Temp
Refer to Programming
Instructions for instructions on
entering program locations.
(Wait 3-Seconds)
("Hold In" to Accelerate)
("Hold In" to Accelerate)
PL11
Proceed to next location
to be changed
To exit program mode,
open program switch
Amount Decrease
Amount Increase
Summary of Contents for DAWS0 SERIES
Page 38: ...Part No 112999 1 xx xx 12...