LAUMAS W200-C, Installation And User Manual

Page: 33 / 56

- 28 -
ALARM RELAY CLOSURE
The ALARM relay closing can be enabled or disabled for each of the following alarms: approval
contact (
 );formula not programmed (  ); maximum weight exceeded (  );
minimum weight (

); no increase in weight (

); no decrease in weight (

); fall
(  ); the PC did not read the batching data (  ).

: in presence of alarm, the relay is closed (default)
 : the relay is not closed even in the presence of alarm
TEST
-
Input Test:
 : ensure that for each open input  is displayed,  is displayed when the input is closed.
-
Output Test:

: setting

ensure that the corresponding output opens. Setting

ensure that the
corresponding output closes.
-
E/EC Option Test:

: It shows the formula selected by the E/EC option, if the option is not present or is not
active, the message

is displayed.
-
Analog Output Option Test:

: It allows the analog signal to range between the minimum and the maximum values
starting from the minimum.
 : current output test.

: voltage output test.
-
Millivolt Test:

: displays the load cell response signal in mV with four decimals.
DATE AND TIME SETTING
Selecting the  item in the main menu, access is obtained to the date and time display menu.
Pressing ENTER several times scrolls through days - months – years and hours – minutes; pressing
◄ selects the figure to modify; pressing ▲ the figure increases; pressing ENTER you can confirm
and go to the next menu item.
+   
+   
+   