Lauda Viscotemp 15 G, Operation Manual

Page: 59 / 132

09/2021
ECO Gold 59 / 134
8.3.4 Cleaning the condenser
8.3.4.1 Air-cooled condenser
The cooling circuit is largely maintenance-free. Remove dust and
contamination from the condenser at regular intervals (depending
on operating period and exposure conditions).
-
To do this, remove the front grille by grasping it at the
bottom with both hands and pulling the grille to the front.
To avoid damage, remove the front grille slowly and care-
fully.
-
Then brush down the condenser and, where necessary,
blow it out with compressed air.
Note:
Caution!
Contact with sharp-edged vanes on the condenser
during cleaning
Cuts

Clean the condenser with suitable tools (e.g. hand brushes,
compressed air...).
8.3.4.2
Water-cooled condenser
To obtain the full cooling output, the sieve and water circuit must be cleaned at regular intervals.
Cleaning the screw-in sieve
For regular cleaning (depending on the degree of contamination of the cooling water) screw-in sieve:

Remove the water supply hose from the device.

Unscrew the fitting from the device with a 19 AF open-ended wrench and remove the screw-in sieve from
the fitting.

Clean the screw-in sieve and then insert in back into the fitting.

Mount the fitting and the water supply hose onto the device.