Lauda VC 1200, Operating Instructions Manual

Page: 88 / 112

Code English output Description
111 SW Safety too old Software version of safety system too old
112 SW Command too old Software version of command remote control unit too old
113 SW Cool too old Software version of cooling module too old
114 SW Analog too old Software version of analogue module too old
115 SW Serial too old Software version of serial interface (RS232) too old
116 SW Contact too old Software version of contact module too old
117 SW Valve 0 old Software version of solenoid valve 0 too old
118 SW Valve 1 old Software version of solenoid valve 1 too old
119 SW Valve 2 old Software version of solenoid valve 2 too old
120 SW Valve 3 old Software version of solenoid valve 3 too old
121 SW Valve 4 old Software version of solenoid valve 4 too old
122 SW Pump 0 old Software version of pump 0 too old
123 SW Pump 1 old Software version of pump 1 too old
124 SW Pump 2 old Software version of pump 2 too old
125 SW Pump 3 old Software version of pump 3 too old
126 SW HTC old Software version of high temperature cooler too old
127 SW Ext. Pt100 old Software version of external Pt100 too old
128 SW Ethernet old Software version of Ethernet too old
129 SW EtherCAT old Software version of EtherCAT too old
155 CAN buff. overflow Buffer overflow for CAN reception
8.7 Warnings – SmartCool
All warnings of the SmartCool system start with the
prefix 3. The prefix is followed by two additional digits.
These digits are listed in the following table.
Code English output Description
301 CAN receive overflow Overflow during CAN reception
302 Watchdog reset Watchdog reset
303 Missing SM adaptation Adaptation run not performed
304 Pressure switch activated Pressure switch in schema cooling circuit was triggered
305 Clean condenser Clean the condenser
Faults
Variocool 88