Proline Kryomats
YAUE0007 / 2/26/2009
Starting up
31
7
Starting up
7.1
Mains connection
Compare the rating on the nameplate (back of control head and behind the front panel) with the mains
voltage.
For Europe:
Model according to EMC (Electromagnetic Compatibility) directive DIN EN 61326-1 Class B (industrial
and domestic areas), if the nominal current of the current feeding point is >100 A. Otherwise only
according to Class A (industrial areas only).*
* Notice only valid for EU countries
Only for the USA:
Instructions for Class A digital devices
“This equipment has been tested and found to comply with the limits for Class A digital device, pursuant
to Part 15 of the FCC (Federal Communication Commission) Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.”
“This device complies with Part 15 of the FCC (Federal Communication Commission) Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired
operation.”
Only for Canada:
“This Class A digital apparatus complies with Canadian ICES-003” (ICES = Interference Causing
Equipment Standards).
« Cet appareil numérique de la Classe A est conforme à la norme NMB-003 du Canada ».
−
Connect unit only to a socket with a protective earth conductor (PE).
−
No liability is accepted for incorrect mains connections.
−
Ensure that pump connectors without external loads are closed off.
−
Ensure that the unit is filled according to Section 6.2.
7.2
Switching on
−
Check whether the switch at the back of the master control element
is in the "On =
–
" position.
−
Check whether the switch at the front of the master control element
is in the "On =
l
" position.
−
Set the rotary switch on the front panel to "ON =
l
". The unit starts
operating.
−
The green LED in the master control element for "Mains ON" is lit.
