Lauda Mobifreeze M270, Operation Manual, Page: 41 / 94

NOTICE!
Use of impermissible mains voltage or mains frequency
Device damage

Compare the type plate with the available mains voltage and
mains frequency.

Only connect to the power supply if the specifications are
compliant.

When operating the device from the mains, the power
supply must be properly fitted with a protective earth con-
ductor (PE).

Local regulations must be observed.
Please note the following:
n
Note for electric installation on site:

The devices must be protected with a 16 ampere circuit breaker,
fitted during installation (mains fuse on site).

Refer to the type plate or technical data for connection values.
n
Only connect the device to power sockets with a protective earth con-
ductor (PE).
n
Only use the retractable power cable with safety plug for the power
supply.
n
Always pull out the cable completely before operating the device.
n
Operate the device according to local regulations.
6.2 Switching the device on and off
1.
Set the mains switch to the "I" position, see
Ä
Chapter 4.5.1 “Mains
switch” on page 26.

Once the device has started up (after approximately 5 seconds),
the overtemperature alarm [Tmax 1] is shown on the Touch oper-
ating unit display and the alarm signal sounds.
Note:
An alarm can only be acknowledged from the "User" user profile
onward, see
Ä
Chapter 6.5 “Selecting a user profile” on page 45
and
Ä
Chapter 6.4 “Defining user profiles” on page 44.
2. Acknowledge the alarm message on the Touch operating unit display,
Ä
Chapter 7.8 “Resetting an alarm” on page 55.
Switching on the device
Fig. 26: Mains switch
Fig. 27: User icon
V1 Mobifreeze 41 / 93