1 Safety
1.1
General safety instructions
n
The devices can only be operated as intended under the conditions
specified in this operating manual. Any other mode of operation is
considered to be unintended use and could compromise the protection
provided by the device.
n
The devices are not designed for use in medical applications in accord-
ance with DIN EN 60601-1 and IEC 601-1!
n
This operating manual is part of the device. The information in this oper-
ating manual must therefore be kept at hand in the immediate vicinity of
the device. Be sure to carefully store this copy of the operating manual.
If this operating manual is lost, contact LAUDA Service Constant
Temperature Equipment. You will find the contact information here
Chapter 12.3 “Contact LAUDA” on page 53
When operating the device, there is a risk of injury from high and low
temperatures, fire and the presence of electrical energy. These risks posed
by the device have been mitigated in the design to the extent possible in
keeping with the applicable norms. The remaining risk can be reduced using
one of the following measures:
n
If relevant, safety fittings are available for the device. This equipment is
critical to the safety of the device. Appropriate maintenance activities
must be implemented to ensure the device remains in good working
order.
The safety fittings for the device are described in this "Safety" chapter.
n
If relevant, various warning symbols are located on the device. These
symbols must be observed without fail.
The warning symbols on the device are described in this "Safety" chapter.
n
This operating manual contains safety information. This information
must be followed at all times.
n
Personnel and the protective equipment worn by personnel are also
subject to specific requirements.
These requirements are described in this "Safety" chapter.
An overview of authorized personnel and the protective equip-
Chapter 1.10 “Personnel qualification”
Chapter 1.11 “Personal protective equip-
Chapter 1.12 “Structure of warnings” on page 9
for more information on the general structure of safety notices.
1.2
Intended Use
The present device is exclusively permitted to be used for tempering and
delivering non-flammable heat transfer liquids in a closed circuit.
Intended Use
V07
Microcool
6 / 57
