Lauda Integral XT 150, Operating Instructions Manual

Page: 35 / 168

Integral XT
YAWE0028 / 24/06/2016
Preparations
33
6 Preparations
Falling down / falling over of the device on inclined plane
/ table edge
Crushing of the hands and feet
•
Only position the device on level surfaces and not
close to table edges.
Falling down / tipping over of the device
Damage to property
•
Do not tip the refrigerator and never place it upside
down.
6.1 Assembly and siting
−
Site the unit on a flat surface.
−
The unit must not be put into operation if its temperature during
storage or transport has dropped below the dew point.
Wait for about one hour.
−
The device should never be tilted or stood upside down.
−
Do not cover the ventilation openings.
−
Leave free space on all sides (
þ
11).
−
Plug the bus connector of the Command remote control into
the 70S socket and secure it.
Further T-adaptors are available as accessories EKS 073.
−
Check that the drain tap [D] is closed (position 0),
and that the sealing cap on the drain is fully tightened. Tighten
the sealing cap only slightly with the open-ended wrench (AF
19). (There are one to four drain taps depending on the de-
vice).
−
Check that with water-cooled (optional) devices the cooling
water inlet and the cooling water outlet [C] are correct and
firmly connected.
[D]
[D]
[C]
[C]
[D]