Initial Set-Up
General
Initial Set-Up
12/9/20
3-9
3
4.
Replace the bushings, if necessary.
5.
Grease each wheel after 8 hours of use and replace any worn or damaged tires.
3.10 General
Always wait for all motion to stop after disengaging the PTO
shaft. Failure to do so may result in serious injury or death.
1.
Verify that all warning decals are in place, visible and legible.
2.
Verify that all covers and safety devices are properly installed and fastened.
3.
Check that the discharge chute is clear of debris, properly mounted, and in good condi-
tion.
4.
Inspect entire Articulator for loose or entangled parts, debris, obstructions, neglected
tools, or any other possible safety hazards, equipment hazards or projectile hazards.
3.11 Pre-Operation Equipment Inspection Checklist
Perform this inspection prior to each operation of the Articulator.
With the tractor and Articulator parked on level ground, verify that the Articulator is properly
mounted to the tractor and secure.
Verify that the PTO shaft is properly mounted and secure, and the PTO shaft cover retaining
chains are secure.
Check the oil level in the gearbox.
Inspect area around and under the gearbox for any oil leakage.
Set the deck height to the desired level. If necessary, calibrate the deck height.
Check the deck drive belt and idler tension spring for proper installation, tension and condi-
tion.
Clean the entire center deck area (including under the belt cover) of all grease, oil, fuel,
grass, or debris. Ensure to replace all covers, shields, and guards.
Check all deck belts for proper tension.
Clean each entire deck area (including under the belt covers) of all grease, oil, fuel, grass, or
debris. Ensure to replace all covers, shields, and guards.