Lastec 721XR, Owner'S Manual

Page: 28 / 56

Initial Set-Up
Hose Spring Installation
3
3-4 Lastec//092215 Initial Set-Up
8. Turn the Articulator as far as it will go in each direction, and measure the distance
between the rear tractor tire and the Articulator. Adjust the pull bar stops (located on the
front dual wheel legs) to allow a minimum 2” clearance between the tractor tire and the
Articulator when turning.
9. Complete the entire Initial Set-Up section of this manual before attempting to operate the
Articulator.
3.3 Hose Spring Installation
Follow the procedures listed below in sequence to assemble the hose spring from the
traction unit to the deck:
1. Attach one of the provided tie wraps around the hoses that are connected from the deck
to the traction unit.
2. Attach one of the provided tie wraps to an elevated point on the traction unit.
3. Assemble on end of the provided spring to the tie wrap located on the traction unit.
4. Assemble the opposite end of the hose spring to the tie wrap locate around the hoses.
Pull Bar Stop
2” Minimum
721_056