Page 02
Push down and pull back on the two Thumb Screw Knobs (50B-12) on both sides of the
Handle (50B-05) Until the Pivot Bracket (50B-07) is engaged in Slot #2 of the Handle.
Raise the Handle to the maximum position.
Make sure the Adapter Plate has been removed.
Insert the Large Size Cutting Unit into the Wooden Top Plate (50B-01) by tilting it
approximately 45 forward and seating it by pushing back and down until it is secure in
place. Make sure the Rotation Tab on the Cutting Unit slips under the Wooden Top Plate
into its designated groove to prevent unwanted rotation of the Cutting Unit. Turn the
Adapter Hold Down Tab (50-11) so that it locks the Cutting Unit into place.
Depress the Handle up and down a few times to check the action of the Cutting Unit. Make
sure the Pivot Bracket is correctly coming down onto the Cutting Unit.
Align the Side Guide (50-03R) using a straight edge pushed into the corner of the Cutting
Unit. When it is positioned as desired, tighten down the Side Guide using the two
6-32 x 3/4” Pan Head Slotted Machine Screws.
Cutting Unit Installation (Large Sizes)
1.
2.
3.
4.
5.
6.
Large Size Cutting Unit
(Misc Part #)
Thumb Screw Knob (50B-12)
Pivot Bracket (50B-07)
Handle (50B-05)
Side Guide (50-03R)
Wooden Top Plate (50B-01)
Adapter Hold Down Tab (50-11)
6-32 x 3/4” Pan Head Slotted
Machine Screws
Note #1:
When using Large Size Cutting Units sizes 3/4” and 1”, it is important that the Pivot Bracket is
located in the Handle Slot #2 during operation. If the Pivot Bracket is located in either of the
other two Slots, you can damage the Cutting Unit.
Note #2:
When using Large Size Cutting Unit size 1-1/2”, it is important that the Pivot Bracket is
located in the Handle Slot #3 during operation. If the Pivot Bracket is located in either of the
other two Slots, you can damage the Cutting Unit.
Slot #1
Slot #2
Slot #3
Handle Diagram
Rotation Tab
