Trencher TR 120 H
24
-
After short cranking check up if the fuel filter is filled with fuel. At light
knocking you can see darker fuel level in the filter. If this level reaches about
¾ of the filter height, try to crank the engine again by turning the ignition key
shortly.
-
Keep an interval between two starts (standstill) 30 sec at least.
-
After starting do not increase the engine speed immediately. Allow the engine
to run at no more than fast idle speed to warm up the engine and hydraulic oil
for about one minute and then you can set it to its max. speed.
-
Do not leave the machine unattended.
-
If you heard any strange noise or vibrations or felt a strange smell while
working, then turn off the machine immediately and contact your dealer or
directly the manufacturer.
Transport, Handling and Storage
-
This machine is allowed to be transported to site either on a
trailer or on a low-bed truck. It is not designed to go on public roads.
-
Special trailer for transport optionally.
-
When loading the trencher on a trailer, let the chain bar sink carefully on the
loading floor, fasten retention chains, straps or cables to the machine chassis.
Do not put them over or against hydraulic hoses. Make sure that they do not
cause damage to rubber tracks. Fasten each corner of the machine and fasten
the front arm to the trailer / vehicle bed with a chain / strap or a suitable
anchor.
-
Remember to use a purpose-designed ramp or a loading platform for loading
and unloading the trencher. The ramp must be strong enough to support the
weight of the machine (min. carrying capacity of 1000 kg).
-
Do not load the machine by means of ramps if the height of the given loading
area exceeds 750 mm. In this case the ramps should be 3,6 m long at least to
avoid rollover risk.
-
While loading/unloading, proceed always slowly and very carefully. Keep an
eye on proper contact between the tracks and the ramps.
-
Avoid any handling with inclination exceeding the permissible limit of 12
o
.
-
While moving and loading the trencher, let always the chain bar lifted
and the engine turned off.
-
When going to another working site go always ascend and descend slopes and
proceed very carefully. Work and motion in hilly fields require more working
experience.
Summary of Contents for TRENCHER TR 120H
