Manual / Bedienungsanleitung: EL-200 LED
Version / Stand: Jun-13
Page / Seite 5 of / von 10
3
4
8
128
4
8
9
256
5
16
10
Mode switch
The address is the sum of all activated numbers, see the following example settings (the white
rectangle represents the position of the switch)
:
Addr
switch
addr
switch
1
65
17
113
The laser uses 7 DMX channels, so make sure that the next device uses an address that doesn’t
overlap with this range. E.g. when using address 1, make sure the next device uses at least address
8.
Channel Value
1
0 – 63
Laser off
64 – 127
Sound mode
128 – 191 Automatic mode
192 – 255 DMX mode
2
0 - 255
Pattern
3
0 - 255
Speed
4
0 - 255
Rotation
5
0 – 39
Red
40 - 79
Green
80 – 119
Red/Green
120-255
Flashing red/green (with increasing speed)
6
0 – 24
Normal operation
25 – 49
Laser on, LED flashes
50 - 74
Laser, LED flash alternating
75 – 124
Laser, LED flash synchronous
125 – 174 Both on
175-199
LED only
200-224
Laser only
225-249
Both off
250 - 255 Normal operation
7
Colour LED
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the 2 upper screws on one side panel (one front and one back), then
bend side panel outward and slide out the top. Remove any deposits of dust, especially at the fan.
Check for condensed fog fluid inside, if so, clean and rearrange the position of laser and or hazer.
Mirrors need cleaning, when a “halo” is noticeable around the beam, or an unusual high amount of
diffuse light can be seen inside the device.
Clean the mirrors with window cleaner and a paper towel.
