User manual: CS-500RGBV
Rev: 08/2009
page4 of 6
ILDA mode
When an ILDA compatible interface is connected to the laser, the laser is automatically
switched to ILDA mode. Output is then controlled from a PC running software.
The laser uses pins 4 and 17 of the IDLA signal to detect the presence of an ILDA interface.
Further information can be found in the software manual.
DMX mode
Channel
Value
Function
0~49
Musik active
50~99
Automatic mode / beam effects
100~149
Automatic mode / graphics
1
Mode
150~255
DMX mode
0~5
No beam
6~15, 16~25, 26~35
red, green, yellow (more colours with RGB/V
models)
36~105
Automatic change red/green/yellow
Slow to fast
106~175
Colour change (original pattern colours)
176~245
Pattern randomly coloured
2
Colour
(multicolor models)
246~255
Original pattern colours
3
Pattern
0~255
249 patterns
0~127
Static movement
128~191
Automatic movement up to down (slow to fast)
4
Vertical movement
192~255
Automatic movement down to up (slow to fast)
0~127
Static movement
128~191
Automatic movement right to left (slow to fast)
5
Horizontal movement
192~255
Automatic movement left to right (slow to fast)
0~127
Static rotation
6
Vertical rotation
128~255
Automatic rotation (slow to fast)
0 ~127
Static rotation
7
Horizontal rotation
128~255
Automatic rotation (slow to fast)
0~127
Static rotation
128~191
Automatic rotation clockwise (slow to fast)
8
Rotation
192~255
Automatic rotation ccw (slow to fast)
0~85
Automatic (small to big)
86~170
Automatic (big to small)
9
Zoom
171~255
Autom. (small to big to small etc.)
10
Size
0~255
Size
11
Pointdraw
0~255
Only points are drawn (slow to fast)
0~127
Piecewise drawing of the pattern
12
Drawing
128~255
Piecewise drawing/erasing of the pattern
Maintenance / cleaning
Always disconnect from mains before cleaning/opening the laser. Regularly clean the interior
from dust, especially ensure operation of the fans. To open the device remove two screws
on the top side of one side panel (front/back), bend the side panel slightly outwards, and
slide the top cover out. Use a sponge with alcohol, rather than wet cloth or other chemical
liquid, to clean the mirrors. Be careful, even light scratches reduce the output power of the
laser. Mirrors need cleaning, when a “halo” is noticeable around the beam, or an unusual
high amount of diffuse light can be seen inside the device.
Technical specifications
•
Lasersources:
aircooled DPSS Laser
•
Power (of the diodes):
typical 500mW, minimum 350mW, 50mW 532nm green,
150mW 650nm
red, 150mW 410 (+/-5)nm blue
•
Laserclass:
3b
•
Modes:
ILDA, DMX 512, auto, music active
•
ILDA:
25pin ILDA standard Sub-D shaped 25pin connector
•
Galvos:
20k scanspeed
•
DMX 512:
12 channels
•
Patterns:
249
•
Scanangle:
ca. 40°
•
Beam:
ca. 3mm/1mrad
