User manual: CS-500RGBV
Rev: 08/2009
page3 of 6
Keep surrounding dry and clean. T
his unit should be keep dry, do not use in the rain or
damp and dusty environment. Projector should be put in a water-proof housing when
operated outside.
Regularly open the device (see “cleaning” further down) to check for dust inside, or if fog
fluid condenses in the housing (if so rearrange hazer and/or laser position).
Operating temperature is 10~35
°C
. In a new installation, check after some 15-30 minutes
whether the outlet air gets too warm. Regularly check the inside for dust deposits, especially
around the fans. Let laser cool off 10minutes after 2 hours of operation,to ensure maximum
lifetime for the diode.
Distance between laser aperture and projection screen should be not less than 1 meter.
Do not turn device on and immediately off again frequently.
Do not look into the laser beam directly, especially not with optical instruments.
Do not touch the device with wet hands.
When the laser diode becomes dim or broken, please contact your dealer timely.
When returning laser to dealer/manufacturer always use original packaging.
Maintenance should be performed every 15-day period. See “cleaning” further down.
Using the laser
Make sure the correct voltage is used. Connect mains. Connect an emergency switch to the
9-pin connector on the backside (pins 1, 2). If you do not wish to connect an emergency
switch, connect the 9-pin plug. Depending on the mode selected (see below), laser light
should come out of the opening on the front panel – be careful.
Control panel
Operating modes
The following operating modes can be selected from the DIP switch on the backside of the
device:
DIP switch 1-10
Mode
0,0,0,0,0,0,0,0,0,0
Music activ
1,0,0,0,0,0,0,0,0,0
Automatic mode / beameffects
1,1,0,0,0,0,0,0,0,0
Automatic mode / graphics
x,x,x,x,x,x,x,x,x,1
DMX
“Music activ”:
patterns are changed/animated to the beat of the music. Sensitivity can be
adjusted with the knob on the back of the device.
“Automatic mode”:
patterns are changed automatically
“DMX“:
DMX512 Modus-. Use the first 9 switches to select the address:
X
x
x
x
x
x
x
x
x
1
2
4
8
16
32
64
128
256
e.g.
1000 0000 01, DMX mode address 1 (1+0+0+0+0+0+0+0+0+0)
0010 0100 01, DMX mode address 36 (0+0+4+0+0+32+0+0+0)
1
Power switch: power on/off
2
Remotelock: connect emergency switch. If
no emergency switch is connected use the
9 pin plug supplied.
3
DIP switch: DMX address/mode selection
(see below)
4
DMX 512 in/out
5
Music mode: sensitivity
6
Microphone
7
Safety switch: laser on/off
8
ILDA connector
