PW-BAT5A
QUICK START GUIDE
PRODUCT CONNECTION AND USE
Charging the Power Bank
Using the USB cable provided, plug the cable into the PW-BAT5A (mini-USB end) and then into your charging device
(standard USB end) such as mains power adaptor, PC etc. The LED light display will then start to flash. It is recommended
that you charge the unit overnight before the first use. Then top up the unit as needed.
On/Off button
To turn the device on, hold the on/off button down until the LED lights turn on
To turn the device off, hold the on/off button down until the LED lights turn off
Charging your device
Once you have turned on your PW-BAT5A and connected your device for charging (and iPhone for example), press and hold
the on/off button until the charging bar on your connected device has indicated that charging has begun.
LED light display
When the unit is turned on, you can momentarily press the on off button to display how much charge the device has left.
Note: The power status will display for 4 seconds. These lights indicate how much charge remains for charging.
All lights on = 80%-100%
3 lights on = 55%-80%
2 lights on = 30%-55%
1 light on = 5%-30%
No lights on = less than 5%
Product Specification
USB OUT PUT 1 - 5V 1AMP: Suitable for iPod, iPhone and mobile devices
USB OUTPUT 2 - 5V 2.1AMP: Suitable for iPad, Samsung P1000, Moto MH900 and MID
Built-in battery capacity: 5000mAh
Intelligent protection for over-charge, over-discharge and short-circuit protection
What’s in the box
Back up battery charger, 1 universal charging cable and 4 charging tips
For further product information and instruction please visit our product
web page at
www.laserco.net
or email
Please note: As continual improvements are made to this product, slight operational differences may occur.
For the most up-to-date user manual, please visit our web site.
