Laser Technology TruPulse 200X, User Manual

Page: 37 / 62

Section 4 – System Setup Mode
Page 33
Inclination Offset
The Inclination Offset is a user offset or value that will be
added to or subtracted from all measured inclination values.
1.
Short press until the INC option is displayed.
2.
Short press the button to begin the process.
3.
While looking through the eyepiece, you will see
the inclination values are updated as the unit is
tilted at +/- angles.
4.
Tilt the laser to the desired angle and press .
This angle is now the new “zero” angle for inclination
measurements.


Press to cancel the setup.

Any angle can be the new “zero”.

To return to the inclination to a normal zero.

Perform a factory reset

Place the unit on a flat level surface and perform the sequence
above.

Each time the TruPulse 200X is powered ON, it will return
to the same Inclination Offset setting that was last used.
Figure #23
Figure #24
Figure #25