Section 3 - Basic Operations
Page 13
Measurement Bar Scale
Figure #6 shows the two Measurement Bar Scale modes: Solid and Gap.
The Measurement Bar Scale mode is stored in memory, the last mode used is
maintained when the unit is powered on.
Refer to the instructions below to change the Measurement Bar Scale mode.
1. Long press the HUD button to toggle to the other scale. A message
corresponding to the new scale “GAP” or “SLd” is displayed in both
the in-scope LED and external LCD display .
¶
The unit will return to normal system operation approximately
3 seconds after the last button press.
Neck Strap
L
In most situations, you will find that the Solid Bar Scale works best in
the BAF Mode, and that the Gap Bar Scale works best in the Diameter
and Height/Diameter Modes.
Solid Bar Scale
Gap Bar Scale
Figure #6
Figure #7
