2
Instruction Manual
Hydraulic Bender “VC1536” “VA1536”
INDEX
1.
BEFORE USING THE EQUIPMENT AND SAFETY ... 2
2.
TECHNICAL FEATURES ............................................ 2-3
3.
START-UP .......................................................................... 3
4.
MAINTENANCE ................................................................ 4
5.
PROBLEMS AND SOLUTIONS ...................................... 4
6.
WARRANTY ...................................................................... 4
7.
DECLARATION OF CONFORMITY ............................. 5
ANNEX
•
GENERAL DRAWINGS.
1. BEFORE USING THE EQUIPMENT AND SECURITY.
LARZEP hydraulic benders are designed in accordance with internal quality standards, in compliance with the ISO 9001 regulation.
If you find any damage or fault with the product, clearly label it and place it in a location where it will not be available for use until an authorized service dealer has
repair the fault.
Never use hydraulic equipment that is damaged or suspected to be in poor conditions.
The tools are designed for the applications described in this manual. Any other use may pose a risk to the equipment and result in hazardous situations for the operator.
The manufacturer accepts no responsibility for damage resulting from the improper use of the tool.
Do no store or leave the hydraulic bender where is can be accessed by the children.
The operator should be fully aware of the risks inherent in the use of high-pressure hydraulic tools, and should act responsibility in accordance with that
described in this manual, ensuring both his/her own safety as well as the safety of others located in the vicinity of the working zone
.
Boots
Helmet
Glasses
Gloves
Clothes
Never modify the tool or add elements that may affect its safety, without express authorisation from the manufacturer.
Before using, check for:
1-
There are not operators standing around dangerous area.
2-
Ensure that the equipment it’s located over firm template.
3-
Do not work around dangerous area.
4-
The commands have been operated with the hands.
5-
Damaged or dirtied connections or coupler.
6-
The flexible hydraulic hoses are not twisted.
7-
The commands are in neutral position.
Check that the working pressure is less than the 80% of nominal capacity
Specialist personnel should only carry out repairs and maintenance operations, etc. Always use original
LARZEP
spare parts.
Carry out maintenance operations on a regular basis, as indicated in this manual.
Once you have finished using the tool, disconnect it, clean it and store it in a clean, safe place.
2. TECHNICAL FEATURES.
The supplied benders in standard equipments are the ones indicated in the enclosed board below. The obtained radius bending the pipe 90º (long radius benders) is also
included
PIPE
INCHES
½”
¾”
1”
1 ¼”
1 ½”
2”
2 ½”
3”
DIAMETER (mm)
21
27
34
42 48 60 75 88
RADIUS
40 60
80
100 115 165 245 290
ANGLE
90
90
90
90 90 90 90 90
All the models include not only a complete bender seal kit in order to fit them in the piston but also two bending rollers with their corresponding grooves to fit in the
pipe.
5
R