2
Instruction Manual
Bench Press with Electric Pump “ECE02013-CE”
INDEX
1. BEFORE USING THE EQUIPMENT ............................................. 2
2. TECHNICAL FEATURES ............................................................. 2-3
3. ESSENTIAL SAFETY REQUIREMENTS ..................................... 3
4. TRANSPORT AND INSTALLATION ............................................. 4
5. MAINTENANCE AND DAMAGES .............................................. 4-5
6. WARRANTY....................................................................................... 5
7. DECLARATION OF CONFORMITY ............................................. 6
ANNEX
•
GENERAL DRAWING
1. BEFORE USING THE EQUIPMENT.
Before unpacking check for:
1.
Oil leaks, signs of corrosion.
2.
Damages in the hydraulic cylinder and the hydraulic line.
3.
Damage sin the frames and accessories of the cylinder.
4.
Damaged screws or connections.
5.
Bad connection of the accessories.
If any anomaly it is detected, avoid the use of it and place it in a safe and far location until be repaired by an authorized service dealer.
Never use equipment suspected to be in poor conditions.
Familiarize the operators with the equipment before using it, and read and follow the instructions and recommendations included in the packaging.
Any improper use, do not observed in this manual, and the omission of the same, may cause personal injuries and material damages which LARZEP, S.A. will not be
responsible.
Do not loose the instruction manual.
Do not work with the equipment near of the flames, explosives, warm intense sources, or any other source which may produce fire, or which may produce damages
in the equipment. The hydraulic equipment must not be exposed to temperatures greatest than 60ºC, as on use as on storage.
If you are purchasing a cylinder or pump, for the use of it in the press, make sure that you are using a correct combination before assembling it. We
recommended, asking for advice in this questions to our technicians.
When a place to the press is located, make sure that there is in a stable surface, is to say, that all base of the press, be supported. If any doubts exist about this
question, it is recommended that distribute the weight in a bigger area, placing a steel shell behind the press’s base.
Store the press when the piston is fully retracted. It is recommended protecting the cylinder with a plastic, or place the press in a clean area, for not damaging the
components and for keeping the press correctly storage.
Never locate the press or store in a place where the children could access to it.
2. TECHNICAL FEATURES.
HYDRAULIC CYLINDER
MODEL KC02013
•
Push capacity (ton)
20 ton
•
Maximum pressure (Kg/cm
²
)
700 Kg/cm
²
•
Stroke (mm.)
130 mm.
•
Effective area (cm
²
)
33.18 cm
²
•
Oil capacity (cc)
431.37 cc.
•
Approach speed (mm/sg)
31 mm/sg.
•
Working advance speed (mm/sg)
5.8 mm/sg
HYDRAULIC MOTORPUMP. REF: HAM7224B
MODEL HAM7224B
Tank capacity
5 Litros útiles.
Volume in low pressure. Approaching
4 Litros/min
Volume in high pressure. Working.
0.36 Litros /min
Maximum pressure.
700 Kg/cm
²
Control valve AZ8200
Manual Aluminio: 3 vías, 3 posiciones.
Motor
0,75 kW a Tensión: 400V. 50 Hz.3ph.