3
Instruction Manual
Hydraulic Cutter “CK0016”
2. TECHNICAL FEATURES
MODEL: CK0016
CK0016
Push capacity (700 kg/cm
²
)
135kN
Length
489 mm
Weight
5,10 kg
PERFORMANCE
bar
CHAIN
3. START UP
1.
Make sure about the knowledge of cutter using and who it work.
2.
Test the circuit, pumping oil into the tool. Opening the return valve (if it is necessary) to checking the blade return. Check the tool at maximum pressure,
working the piston against the limit of stroke and return the blade. Repeat this operation to get used to the circuit.
3.
Insert the chain link or bar in the gap between blades (max. 30 mm.).
4.
Centre the material to be cut in the gap and look for the alignment with the tool.
5.
Actuate the pump until the material is broken. Return the movable blade by releasing the pump.
4. MAINTENANCE
REPLACEMENT OF BLADES
•
Fixed blade:
Loosen the screw (20), and push the blade with a nail through the head hole. Remove the damaged blade, put a new one and tighten the screw (20).
•
Movable blade:
Dismantle the screws (17), at the both side, and loosening the second screw (17), it is possible to unscrew the body from the head.
Next step, dismantle the piston, and unscrew the bolt (8), to get the blade free.
Put a new one and proceed opposite way to mount back again, controlling the position of the flat side of the piston.
The screws (17) work like the piston guide. Lock the screws leaving a enough gap for a well work of the spring.
REPLACEMENT OF SEALS
After dismantle the piston, unscrew the bolt (6), and pull out the piston from the body. Replace the seal and segment for the new ones. Do not use sharp edged tools.
Use spare parts from LARZEP.
Take this opportunity to change the O-ring (18) and (21) and the guide (14).
To mount back again, proceed opposite way.
5. WARRANTY
LARZEP, S.A.
guarantees its products against all design and manufacturing defects for the durations of two years from the date of purchase. This guarantee does not
include the ordinary wear of both metal and non-metal parts, abuse, using the equipment beyond its rated capacity and any wear or damage incurred as a result of
using a hydraulic fluid which is not recommended by
LARZEP, S.A.
Please note that if the equipment is disassembled or serviced by anyone other than an authorized service dealer or by
LARZEP, S.A
., this guarantee is rendered null
and void.
In the event of a warranty claim, return the equipment, to
LARZEP, S.A
. or the authorized dealer which sold you the hydraulic equipment,
LARZEP, S.A
. will
repair or replace the faulty equipment, whichever is deemed most appropriate.
LARZEP, S.A.
shall not be held liable for any consequential damages or losses,
which may occur as a result of faulty equipment
CK0016
Bar diameter mm
Strength kg/cm
²
11 min.
19 max.
1600
700
CK0016
Chain Diameter mm
Strength by grades
Standards
14 min.
19 max.
60-80
28-43-50
ASTM-413, DIN5684,
DIN5685, DIN764,
DIN766, DIN762