WAL-QP-4XWP60E-25-1227
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
240 Watt LED Work Area Tripod Light Fixture
500 Watt Quartz Halogen Replacement - Waterproof
Instruction Manual
The WAL-QP-4XWP60E-25-1227 Tripod Mounted LED Work Area Light from Larson Electronics produces
21,600 lumens of bright flood light and is an economical direct replacement for 500 Watt quartz halogen flood
lamps. This adjustable LED light tower is designed for portability and durable operation and ideal for use in
demanding conditions.
WARNING: Read all instructions carefully
SAVE THESE INSTRUCTIONS
CAUTION: RISK OF ELECTRICAL SHOCK
•
Do not use with extension cord near water or
where water may accumulate.
•
Keep plugs and receptacles dry.
•
For use only on GFCI protected circuits.
•
Risk of burns, do not operate without lens.
•
Lighted lamp is hot. Keep away from
combustibles. Unplug to change bulb.
WARNING RISK OF FIRE, ELECTRIC SHOCK,
EXPOSURE.
•
Unit operates on 120/277 VAC 50/60Hz only
•
Unplug and allow cooling before replacing bulb.
•
Do not touch hot lens guard or enclosure.
•
Do not remain in light if skin feels warm.
•
Do not look directly at lighted lamp.
•
Do not operate the lamp with missing or
damaged lens or lamp containment barrier.
TRIPOD ASSEMBLY
The tripod assembly consists of 3 parts:
1.
Light head
2.
Pole w/Legs
3.
Wheel base
To assemble tripod, begin by placing the legs over the wheel base. Tighten bolt to secure the wheels.
The tripod can now be rolled around on its wheels. Ensure the legs are folded up before tilting tripod
to maneuver.
WARNING:
Use caution before tilting tripod with a heavy load. For heavy loads, it is recommended to
remove the light head prior to transporting via wheel base! Failure to do so may cause serious injury
or death. Larson Electronics shall not be held liable for injuries caused by misuse.
1.
Place tower in desired location that is flat and able to support the tripod without falling over.
2.
Loosen hand screw and lower legs until firmly stabilizing tripod.
3.
Tighten hand screw to secure legs.
4.
With help, place the light head over top pole and tighten hand screw.
Light weight lamps can be attached by tilting tripod toward the ground with the legs up. Attach light
head to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt tripod while
extended to max height. It is recommended to have another person hold the tripod while tilting
vertically.
For heavy weight lamps, use a ladder and extra help for attaching light head to pole.
Double check that all hand screws are tight before continuing use of the light tower.
