Larson Electronics RCL700, Instructions And Operator’S Manual

Page: 1 / 2

Larson Electronics, LLC . ( RCL700 rev 0 7 - 27 -201 8 )
Troubleshoo ting
If your RCL700 stops opera ti ng, please check for the following condi ti ons:
1. Check the ba tt eries in the wireless remote.
2. The inrush current for an incandescent lamp is typically ten to fift een ti mes the opera ti ng
current and an HID switching power supply inrush current can be even greater. This high
inrush current can cause a severe voltage drop if the power feed wires are long, under size or
the power supply is weak. This may cause the receiver circuit to enter a low voltage shutdown
state. It is recommended to only turn on the lights while the vehicle is running. The power to
the RCL700 needs to be cycled o ff and back on to reset the shutdown circuit.
3. The motor control circuit is overcurrent and over temperature protected in the event the light
is jammed against an imovable object. The power to the RCL700 will need to be cycled o ff
and back on to reset the overcurrent/over temperature circuit.
Remote Control Spotlight
Instruc ti ons and Operator’s Manual
Contact Larson Electronics
For ques tio ns, sales or service please contact:
Phone: 800-369-6671
Fax: 903-498-3364
Email:
Web:
sales@ larsonelectronics.com
www. larsonelectronics .com
Address: Larson Electronics, LLC.
9419 US-HWY 175
Kemp , Texas 75143
USA