95
11
Network Configuration
Network configuration is required if your NVR operates in a
network shared by other devices.
NOTE!
The default IP address is 192.168.1.30 for NIC 1 and 192.168.2.30
for NIC 2.
Basic Configuration
TCP/IP
1.
Click
Network > Basic
.
2.
Set the network parameters as needed. DHCP is enabled by
default.
You can choose a working mode if the NVR has two NICs:
Multi-address mode
: The two NICs work independently
and can be configured separately. Either NIC can be
chosen as the default route; data will be forwarded
through this NIC when the NVR connects to the
extranet.
Load balance mode
: The two NICs are bound to the
same IP address and work together to share network
traffic.
Net fault-tolerance mode
: The two NICs are bound to
the same IP address. In cases where one NIC fails, the
other takes over service seamlessly from the faulty one
to ensure network connectivity.
