ALU-TP-W-58
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Collapsible Aluminum Quadpod on Wheels
7 to 12 Feet – Removable Tower Head
Instruction Manual
QUADPOD ASSEMBLY
The quadpod assembly consists of 4 parts:
1.
T-head
2.
Extension Pole
3.
Leg Base
4.
Wheel Base
To assemble quadpod:
1.
Begin by placing the wheel base in a flat level area.
2.
Place legs over the wheel base.
3.
Tighten screw to secure the wheels.
4.
Slide Extension Pole over the Leg Base and tighten hand screw.
5.
Loosen legs and slide down until fully deployed. Tighten hand screw.
6.
Finally, attach T-head over top Extension Pole and tighten hand screw.
The quadpod can be rolled around on its wheels. Ensure the legs are folded up before tilting quadpod
to maneuver.
Use appropriate measures to attach equipment to the top of T-head. Predrill holes through top and
bottom and utilize bolts for mounting heavy equipment.
WARNING:
Use caution before tilting quadpod with a heavy load. For heavy loads, it is
recommended to remove the T-head prior to transporting via wheel base! Failure to do so may cause
serious injury. Larson Electronics shall not be held liable for injuries caused by misuse.
1.
Place tower in desired location that is flat and able to support the quadpod without falling over.
2.
Loosen hand screw and lower legs until firmly stabilizing quadpod.
3.
Tighten hand screw to secure legs.
4.
With help, place the T-head over top pole and tighten hand screw.
Light weight devices can be attached by tilting quadpod toward the ground with the legs up. Attach T-
head to pole, tighten hand screw and tilt back to its vertical position. DO NOT tilt quadpod while
extended to max height. It is recommended to have another person hold the quadpod while tilting
vertically.
For heavy equipment, use a ladder and extra help for attaching T-head to pole.
Double check that all hand screws are tight before continuing use of the quadpod tower.
