Lapple FIBRO FIBROTOR VM.NC, Assembly And Operation Manual

Page: 25 / 50

5 ASSEMBLY
5.1 IMPORTANT SAFETY GUIDELINES
FIBROTOR 25 | 50
5 Assembly
5.1
Important safety guidelines
Incorrect installation
The assembly work should be performed by qualified personnel only. Work on the
power supply line connections should be performed by qualified electricians only.
A check must be carried out to ensure that the power supply frequency and
voltage correspond with the data in the technical specification. The electric,
hydraulic and pneumatic devices must be connected only when the power supply
is turned off. Crushing and electrocution injuries.
When assembling the rotary table or its components, the following must be
ensured:
•
the assembly site is suitable for the operational weight, including the
superstructural parts of the client and the tools.
•
the expected loads, torques and moments of inertia have been taken into
consideration.
•
the assembly site has been isolated with a signal strip.
•
the assembly site has been marked with danger signs.
•
only authorised persons have access to the work area and no other persons
could be endangered by the assembly work.
5.2
Installation requirements
The assembly site must be prepared for the assembly work and has to be clean
and even.
The mounting bolts must be available.
5.3
Assembly of the rotary table
5.3.1
Mechanical assembly
Rotary table damage. The rotary table should not be
braced while being bolted. The maximum bolting depth and the tightening
moments of the mounting bolts as well as the maximum offset for the cylindrical
pins must be observed.