XPress™ DR+ Industrial Device Server User Guide
53
8: Setup Mode: Channel Configuration
This chapter explains how to configure a serial port.
Notes:
Current values display in parenthesis.
You must enter some values in hexadecimal notation.
(See
E: Binary to Hexadecimal Conversions
.)
Channel 1 (Option 1) and Channel 2 (Option 2)
Note:
Channel 1 and Channel 2 have the same defaults except for the port number (10001 for
Channel 1 and 10002 for Channel 2).
Select
Channel 1
(option
1)
or
Channel 2
(option
2
)
from the Change Setup menu to define how
the serial port responds to network and serial communications. The following sections describe
the configurable parameters within the
Channel
configuration menu.
Figure 8-1. Serial Port Parameters
Baudrate (9600) ?
I/F Mode (4C) ?
Flow (00) ?
Port No (10002) ?
ConnectMode (C0) ?
Send '+++' in Modem Mode (Y) ?
Show IP addr after 'RING' (Y) ?
Auto increment source port (N) ?
Remote IP Address : (000) .(000) .(000) .(000)
Remote Port (0) ?
DisConnMode (00) ?
FlushMode (00) ?
DisConnTime (00:00) ?:
SendChar 1 (00) ?
SendChar 2 (00) ?
Baudrate
The unit and attached serial device, such as a Programmable Logic Controller (PLC), must agree
on a speed or baud rate to use for the serial connection. Valid baud rates are 300, 600, 1200,
2400, 4800, 9600 (default), 19200, 38400, 57600, 115200, and 230400 baud.
Baudrate (9600) ? _
